Want To Know The Basic Operation Of ET-3000 Built-in Oven Timer?

Want to know the basic operation of ET-3000 built-in oven timer?

1,Software function instruction

Power on: auto icon flashes with the number, and "·" doesn't flash.  The defaulted time is 12:00. At this time, only  button is effective.

(1) Time Set

① When the auto icon doesn't light up, clicking  button to enter into time set mode.

② Under the time set status, the timer will display current set time, and "·" flashes.

③ Clicking  or  to change time,  short pressing  or , increasing or decreasing 1 min; long pressing  or  to change time quickly.

④ The time is set to 24 hours

⑤ Under the time set mode, if there is no operation within 6s, then exiting time set mode, and the decimal point doesn't flash.

Alarm

⑥ Clicking  button to enter into alarm set mode.

⑦ Under the alarm set model, the default time is 0.00, alarm icon flashes. Clicking  or  to change time

⑧ Under alarm set mode, if there is no operation within 6s, then the timer will exit alarm mode, at this time, digital tube will display current time. After exiting, if the set time is over 0, the alarm icon is always on; If the set time is below 0, the icon will not light up.

⑨ Under alarm set mode, if the set time is over 0, the timer will start after exiting the setting. When the timer is over, the alarm icon blinks and synchronizes with the buzzer.

⑩ Alarm set time range 0·00---10·00

Starting time set

⑪ The user clicks  button to enter into set state of starting time.

⑫ Under set state of starting time, auto icon flashes, and digital tube displays "dur and 0·00, which will flash alternately.

⑬ When the end time is finished setting, at this time, starting time will be defaulted as ending time- current time,then setting starting time again, and the starting time can't be over the figure , only can be decreased and can't be increased.

(2) Ending time set

① The user clicks  button to enter into set state of ending time.

② Under set status of ending time, auto icon flashes, and digital tube displays "end " and current time , which will switch alternately.

③ Under set status of ending time, if there is no operation within 6s, then the timer will exit set status, and digital tube displays current time. If set ending time is over current time,  the auto icon is always on ; If set ending time is equal to current time, the auto icon is not on.

④ When the starting time is not set and the ending time is set directly, then the starting time has been set as ending time-current time by default.

(3) Heating on/off conditions

① After the first power on or after the last baking, clicking  button to light up heating icon and starting heating.

② If the starting time is set longer than 1 minute and the ending time is not set, the heating icon lights up and starts to heat ( starting during setting). At this time, the heating icon is still  on even if the starting time is adjusted as 0·00 .  When the timer finishes, ending and closing Heating icon and Heating.

(4) Child Lock: Without setting parameter, long pressing  button for 3s to light up key icon, and other buttons will be useless. Long pressing  button for 3s to exit child lock, closing key icon and other buttons will be available again.

(5) The buzzer set

① Long pressing button for 1s to enter into buzzer set status.

② During the buzzer set status, digital tube display ton1 by default, clicking  button to switch sound (1-2-3-1 by order), ton1 sound is sounder, ton2 is lower, ton3 has no button sound. The buzzer keeps sounding with long pressing. It doesn't stop until you loosen your grip.  Without operation for 6s or clicking  to exit buzzer set status.